Product properties and application
Titebond All Purpose White Glue is an all-purpose white PVA glue for wood, paper, cardboard, fabric, ceramics and other porous materials. Suitable for crafts, models, home repairs and indoor woodworking. The glue dries clear.
Impressive bond strength of approximately 249.6 kg/cm². In the manufacturer's ASTM D905 test on hard maple joints at room temperature, Titebond All Purpose White Glue achieved a shear strength of 3550 psi (approximately 24.5 MPa).
- ✓ All-purpose PVA glue for porous materials
- ✓ Strong initial grab
- ✓ Dries clear
- ✓ Non-toxic
- ✓ Paintable
- ✓ Water clean-up before curing
Bond strength: 249,58 kg/cm²*
Open assembly time: 5 min.
Total assembly time: 10-15 min.
Application temperature: above +10 °C.
Shake the container thoroughly before use to ensure a uniform consistency and viscosity.
Preparation and bonding. Surfaces must be clean and dry. Apply a thin, even layer using the bottle nozzle, a brush or a roller. Join the components and keep them pressed together until the required bond is achieved. Recommended clamping pressures for each material are listed under Physical properties.
Clear glue line and cleaning. The white glue dries clear and the bonded area can be painted. Clean uncured glue with water or a damp cloth. Scrape or sand off cured excess.
Application limitations. For porous materials indoors. Do not use outdoors or where moisture exposure is likely. For exterior woodworking, choose Titebond II Premium or Titebond III Ultimate as appropriate. Air, glue and material temperatures must be above +10 °C.
Not intended for structural bonding of load-bearing building components. If proposed for a joint with additional mechanical fixings, the suitability of that arrangement must be assessed by the structural designer.
Non-toxicity and safe use. Titebond All Purpose White Glue is non-toxic and conforms to ASTM D4236. Read the Safety Data Sheet before use and follow its instructions. Keep out of children's reach.
Storage. Protect from freezing. Shelf life is 24 months in a tightly sealed container below +24 °C. Frozen glue may thicken; stirring should restore its original consistency. Check that the glue is uniform before use.
*Bond strength measured by bonding maple to maple at approximately +21 °C: 24.47 N/mm² / 249.58 kg/cm². Assembly times are given at +21 °C and 50 % relative humidity. Results and working time depend on the materials, surface preparation and bonding conditions.
Application examples are available under Video, with full information in the attached Lithuanian PDF.
