Product properties and application
Titebond Instant Bond THICK is a high-viscosity instant cyanoacrylate (CA) adhesive primarily designed for wood and wood products, and also suitable for metal, plastic, rubber and other compatible materials. Its thick consistency helps precise dispensing and gives more time to align components than the fluid THIN adhesive. Particularly suitable for MDF, porous wood, end grain, turning blanks and small joint gaps.
Impressive bond strength of 196.85-295.28 kg/cm². Strength depends on the materials and test conditions.*
- ✓ Thick – 2400 cps viscosity
- ✓ Fast initial bond
- ✓ For filling small gaps and cracks
- ✓ For MDF, porous wood and other materials
- ✓ Clear cured glue line
- ✓ Resistant to impact, heat and solvents
Bond strength: 196,85-295,28 kg/cm²*
Viscosity: 2400 cps (2,4 Pa·s).
Assembly time: approximately 10 sec.
Initial bond: approximately 8 sec.
Full cure: within 8 hours.
Joint bonding, gap filling and woodturning. Suitable for quickly joining two components and filling wood cracks, knots and small voids. Used to bond porous surfaces, end grain and turning blocks, and to attach a woodturning piece to a wooden backing block. Keep joined components still and allow the bond to set before loading it.
Resistance and finishing. The cured glue line is clear and resists impact, heat and solvents. It does not interfere with subsequent finishing and can be used as a final finish on turned wood products. Test compatibility with the chosen coating on a small area first.
Compatible materials. Wood, MDF, PVC, acrylic, natural rubber, glass, nylon, brass, aluminium, stainless steel, chrome, granite, polyester, polystyrene, porcelain, ceramics, leather, gemstones and fibreglass. Test compatibility with the specific surfaces in an inconspicuous area first.
Preparation and bonding. Surfaces must be clean and dry. Prepare components in advance and check their fit. Dispense small quantities. Rapid bonding can eliminate the need for clamps or shorten clamping time, depending on the joint and working conditions.
Curing. Assembly time approximately 10 seconds; initial bond approximately 8 seconds. The technical data also state a 30-second curing stage. Full cure is reached within 8 hours. These times describe different stages and depend on the materials and ambient conditions.
Use with an activator. Works without an activator. Titebond Instant Bond Activator can reduce initial setting time by approximately 50 %. This is not the full curing time.
Product purity and dispensing. Triple-distilled for high purity. The convenient, clog-resistant bottle nozzle helps dispense the adhesive precisely.
Application limitations and storage. For interior use. Do not use outdoors or where significant moisture is likely. Store in a cool, dry place. For best results, bond at temperatures from +12 °C to +30 °C.
Cleaning. Use acetone for cleaning. Check its suitability for the surface in an inconspicuous area first and follow the solvent's instructions.
Safe use. Protect skin and eyes: cyanoacrylate adhesives can rapidly bond skin and eyelids. Follow the label and Safety Data Sheet instructions. Keep out of children's reach.
*Bond strength: 2800-4200 psi / 196.85-295.28 kg/cm², depending on the materials bonded. Compare different test results only after considering the test conditions.
Application examples are available under Video, with full details in the attached PDF documents.
