Titebond Speed Set – exceptionally strong, fast-setting wood glue for furniture making, assembly and interior joinery, visible under UV light.
Product properties and application
Titebond Speed Set is a fast-setting PVA wood glue for interior work, furniture making and wooden component assembly. The white glue dries clear, and residue is visible under UV light, making it easier to identify and remove before finishing.
Impressive bond strength of approximately 293.7 kg/cm². In the manufacturer's ASTM D905 test on hard maple joints at room temperature, Titebond Speed Set achieved a shear strength of 4178 psi (approximately 28.8 MPa).
- ✓ Short clamping time
- ✓ Glue residue is visible under UV light
- ✓ Dries clear
- ✓ Easy to sand
- ✓ For furniture and interior work
- ✓ Water clean-up before curing
Shake the container thoroughly before use to ensure a uniform consistency.
Bond strength: 293,74 kg/cm²*
Open assembly time: 2-4 min.
Total assembly time: 8-10 min.
Application temperature: above +15 °C.
Fast assembly. High solids content and strong initial tack help improve productivity and shorten clamping time. Suitable for furniture making, joinery and bonding wooden components indoors.
Colour and UV inspection. This white glue dries clear. Glue traces become clearly visible under a UV lamp. Remove residue before painting, varnishing or oiling so it does not interfere with an even finish.
Machining and cleaning. The cured glue line sands easily. Remove uncured excess with water or a damp cloth; scrape or sand off cured residue.
Application limitations. For interior use. Do not use outdoors or where significant moisture is likely. For exterior work, select Titebond II Premium or Titebond III Ultimate according to the application. Air, glue and wood temperatures must be above +15 °C.
Not intended for structural bonding of load-bearing building components. If proposed for a joint with additional mechanical fixings, the suitability of that arrangement must be assessed by the structural designer.
Storage and preparation. Protect from freezing. Stir thoroughly before use, or shake the bottle, to ensure a uniform consistency. Stir monthly during storage to reduce settling.
Non-toxicity and safe use. The manufacturer's technical data sheet describes Titebond Speed Set as non-toxic. Read the current Safety Data Sheet before use and follow its instructions. Keep out of children's reach.
*Bond strength measured to ASTM D905 on maple joints at approximately +21 °C: 4178 psi / 28.80 N/mm² / 293.74 kg/cm². Assembly times are given at +21 °C and 50 % relative humidity. Actual results depend on the timber, surface preparation and bonding conditions.
Application examples are available under Video, with detailed technical information in the attached Lithuanian PDF.
