INSTRUCTIONS FOR USE
Use as a polyurethane adhesive release aid. Prieš skleisdami poliuretano klijus nuvalykite kiekvienos lentelės paviršių (viršutinį) su “Titebond Adhesive Remover” servetėlėmis. Tai ženkliai palengvins klijais išteptų vietų nuvalymą. Būtinai kruopščiai nuvalykite ar nuplaukite naujai sumontuotų grindų vietas kuriose naudojote valiklį. WARNING: floors will be very slippery if adhesive remover residue is left on the surface.
Adhesive Removal: Unscrew the container lid, remove and discard the protective seal. Pull the corner of a wipe from the centre of the roll and feed it through the dispensing opening. Close the lid when not in use to prevent the wipes from drying out. If the adhesive has dried for more than 48 hours, place a wipe over it and leave for approximately five minutes, then clean with a fresh wipe. Repeat if the surface remains sticky. Once all adhesive residue has been removed, wipe the entire area with a clean, water-dampened towel.
NOTE: when using the wipes on flooring, thoroughly clean every treated area with a clean towel.
