Titebond Melamine Glue – thick, clear-drying glue for furniture making, wood, MDF and particleboard with melamine, vinyl and HPL surfaces.
Product properties and application
Titebond Melamine Glue is designed for bonding wood, MDF and particleboard to melamine, vinyl or HPL surfaces. Intended for furniture making and precise component assembly. At least one bonding surface must be porous.
Strong initial tack and precise assembly. Grabs quickly, while an open time of approximately 5 minutes allows components to be aligned. The thick consistency reduces runs and drips.
A reliable melamine-to-particleboard bond – approximately 23.8 kg/cm². The manufacturer's ASTM D905 test recorded a strength of 339 psi (approximately 2.34 MPa). This result applies to the melamine-to-particleboard test specimen.
- ✓ For wood, MDF and particleboard
- ✓ For melamine, vinyl and HPL joints
- ✓ Strong initial grab
- ✓ Thick consistency – fewer runs
- ✓ Dries clear
- ✓ Water clean-up before curing
Shake the container thoroughly before use to ensure a uniform consistency.
Open assembly time: approximately 5 min.
Total assembly time: 10-15 min.
Application temperature: above +5 °C.
Coverage: 5-6 m²/l.
What is this glue designed for? Bonding porous wood, MDF and particleboard to melamine, vinyl or HPL surfaces. Suitable for furniture making, bonding trim and precise assembly.
Consistency and glue-line appearance. Higher viscosity reduces runs and drips. The white glue dries clear.
Application and cleaning. Spread the glue with the bottle nozzle, a roller or a brush. Remove uncured excess with water or a damp cloth. Scrape or sand off cured residue.
Application limitations. For interior use; not intended for outdoor conditions or continuous immersion in water. At least one bonding surface must be porous. Do not use when the glue or bonding surfaces are below +5 °C.
Not intended for structural bonding of load-bearing building components. If proposed for a joint with additional mechanical fixings, the suitability of that arrangement must be assessed by the structural designer.
Storage and preparation. Protect from freezing. Do not use glue that has frozen and turned into a gel. Shake the container before use to ensure a uniform consistency.
Safe use. Read the product label and current Safety Data Sheet before use, and follow their application and protection requirements. Keep out of children's reach. Contact our technical support if you have questions about application.
Assembly times are given at +21 °C and 50 % relative humidity. Actual working time depends on the materials, temperature, humidity and adhesive layer.
Application examples are available under Video, with wood glue selection information in the attached Lithuanian catalogue.
